Tricity Bendix SB431C (PRESIDENT) User Manual download pdf (Page 8)

WARNING: THIS APPLIANCE MUST BE EARTHED

RATING PLATE

This is situated on the lower front frame of the

appliance and can be seen upon opening the door.

Alternatively the rating plate may also be found on

the back or top of some models (where applicable).

The appliance must be protected by a suitably

rated fuse or circuit breaker. The rating of the

appliance is given on the rating plate.

Do not remove the rating plate from the

appliance as this may invalidate the guarantee.

INSTALLATION

If your appliance has been damaged in transit,

contact your supplier immediately. DO NOT

attempt to install it.

Your appliance left the factory fully packaged to

protect it from damage. If it is delivered without

packaging and damage has occurred, the

manufacturer cannot accept responsibility. Contact

your supplier for advice.

Once the packaging has been removed the

appliance should only be moved by hand. DO

NOT use a sack barrow or any other aid to lift the

appliance as damage may occur.

Connection to the electricity supply must be carried

out by a qualified electrician/competent person.

The electrical connection should be made using a

double pole isolating switch (cooker socket) with at

least 3mm contact separation in all poles. The

cable must have conductors of sufficiently high

cross-sectional area to prevent overheating and

deterioration.

The recommended cross-section area is six square

millimetres (6.00mm

For SB431BTS

The electrical connection must be made using an

all pole isolating switch, or other suitable means of

disconnection, with at least 3mm contact

separation. The cable must have conductors of

sufficiently high cross-sectional area to prevent

overheating and comply with all relevant wiring

regulations.

The recommended cross-section area is six square

millimetres (6.00mm

The cable should be routed away from potentially

hot areas marked by X in the diagram below.

To move the appliance, open the main oven door,

and lift the appliance by holding inside the top of

the oven compartment.

This is a type Y appliance, which means it is free-

standing and can be fitted with cabinets on one or

both sides. It may also be fitted in a corner setting.

A nominal air gap of 2mm at the sides of the

appliance is required to enable the appliance to be

moved into position.

Side walls which are above hob level should be

protected by heat resistant non-combustible

material and MUST NOT be nearer than 40mm to

the hob side.

Overhanging surfaces or a cooker hood should be

a minimum of 685mm above the hob.

It is important to ensure that the appliance is level

after installation. Levelling feet are fitted to the

appliance to accommodate uneven floors.

INTRODUCTION

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments

Tricity Bendix SB431C (PRESIDENT) User Manual Page 8

Comments to this Manuals

Related products and manuals for Ovens Tricity Bendix SB431C (PRESIDENT)