Tricity Bendix CH710X User Manual download pdf (Page 14)

Fitting the Wall Brackets

Wall marking:

• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area

in which the hood will be installed.

• Draw a horizontal line at 650 mm above the hob.

• Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre

(notch) with the vertical reference line.

• Mark the wall at the centres of the holes in the bracket.

• Place bracket 7.2.1 on the wall as shown at X mm below the ﬁ rst bracket (X = height of the upper chimney

section supplied), aligning the centre (notch) with the vertical line.

• Mark the wall at the centres of the holes in the bracket.

• Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above the horizontal

reference line.

• Repeat this operation on the other side.

• Drill ø 8 mm holes at all the centre points marked.

• Insert the wall plugs (not supplied) in the holes.

• Fix the lower bracket 7.2.1 using the two screws (not supplied).

• Fix the upper bracket 7.2.1 and the air outlet connection support 7.3 together using the two screws (not sup-

plied).

• Insert the two screws (not supplied) supplied in the hood body ﬁ xing holes, leaving a gap of 5-6 mm between

the wall and the head of the screw.

Note: If the hood is to be installed onto a hollow construction or plaster or partition board wall then special

ﬁ xing screws will be required (not supplied).

INSTALLING THE COOKER HOOD

12a

306

116

1÷2

116

650 min.

7.2.1

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Tricity Bendix CH710X User Manual Page 14