Tricity Bendix CH710X User Manual download pdf (Page 15)

Fitting the Hood Body

Before starting to ﬁ x the hood body,

tighten the two screws Vr located on the

top of the hood body.

Hook the hood body onto the two

4.2x44.4mm screws item 12a.

Fully tighten the screws item 12a.

Using a screw driver and spirit level,

adjust the screws item Vr until the hood

body is level.

Extraction

The cooker hood is more effective when used in

the extraction mode (ducted to the outside).

Venting kits may be purchased through your

retailer or DIY store, and must be ducted to an

outside vent of Ø125mm (5”) or Ø150mm (6”).

The ducting used must be manufactured from

ﬁ re retardent material conforming to the relevant

British Standard or DIN 4102-B1.

When the cooker hood is ducted to the outside the

charcoal ﬁ lter must be removed.

Recirculation

The cooker hood is supplied speciﬁ ed for use

in the recirculation mode, with the charcoal ﬁ lter

ﬁ tted.

In the recirculation mode contaminated air is

passed through the charcoal ﬁ lter to be puriﬁ ed

and recirculated into the kitchen through the grille

outlets on either side of the chimney.

To assemble the recirculation duct, place the

recirculation outlet connection item 15 into the

support item 7.3.

Insert the extension ducts item 14.1 into either

side of the recirculation outlet item 15 ensuring

the connections are vertically and horizontally

aligned with the outlets in the chimney.

Connect the recirculation oulet item 15 to the

outlet on top of the hood body using either a piece

of Ø125mm or Ø150mm ﬂ exible or rigid pipe.

Rigid pipe is strongly recommended and should

be used where possible as this will ensure the

best performance while lowering noise.

ø 150

14.1

12a

INSTALLING THE COOKER HOOD

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Tricity Bendix CH710X User Manual Page 15

Comments to this Manuals

Related products and manuals for Cooker hoods Tricity Bendix CH710X